As some of you may be aware albeit a new member in our community news travels pretty rapidly that I suffered a minor stroke a month ago causing a problem with vision whilst I can see pretty well I loose focus so I quit flying and buiding.
The foregoing is an introduction to sell my unfinished Mossy it is on RC Groups to view though if you are interested I can send pictures. The model is 1/3 scale the fuselage is finished has servos installed for R/E/Tow has scale pull pull exit and hardware. The elevator hook up is via a an actuator in the stab that slides over the pivot arm and when tail is bolted down gives a secure and positive action. the elevator has a piano wire the whole length that can be removed for painting or maintenance.
Port wing is completed also the aileron servo installed a is wing tubes a typical European method which employs two brass tubes mounted on top of each other giving an almost impossible wing failure. The custom air brakes have been installed but removed for fine tuning to fit. The other wing is basically finished including the aileron but the D box need to be sheeted ter is enough 1/64 sheet ply to finish also the other airbrake needs installing.
Also included is a 10 meter roll of White Solatex
The cockpit is complete with a 3D printed dash panel just minor trim pieces to add also included is a custom canopy. an Axel pilot is also included seller is motivated buyer need to collect Ocala Florida.
Make a reasonable offer.
I also have a Chris Williams designed 1/3 scale Rhonadler finished except painting same buyer to collect
Make an offer
David 352 351 0310